Table of Contents
Advertisement
the motor leads to the spade lugs on the 3-Phase Motor Control Application Board as
shown in Figure 2.
Figure 1. MC MDS Board Mounted on 3-Phase Motor Control Application Board
Step 2. Set Switches
For your initial setup, set the switches on the board as detailed below.
•
Set Direction Switch S2 to the far right position
•
Set Switch S3 to the far right/RUN position
•
Set Speed Potentiometer R7 to its midpoint
Refer to the Z16FMC Motor Control Development Kit User Manual (UM0234) for
detailed jumper descriptions.
QS007901-1110
Z16FMC Series Motor Control Development Kit
Quick Start Guide
Page 3 of 15
Advertisement
Table of Contents
