Build And Run The Z51F3220 Demo Project - ZiLOG Z8051 Series User Manual

Hide thumbs Also See for Z8051 Series:

User manual (55 pages)

Table Of Contents

Table of Contents

Build and Run the Z51F3220 Demo

Project

Observe the following procedure to build and run the Z51F3220 demo project.

1. Browse to the following location and double-click the

build the project:

<Z8051 Installation>\Z8051_<version_number>\samples\Z51F3220\Demo\build_sdcc.bat

Note:

Refer to the

these project files and Small Device C Compiler (SDCC) development tools.

2. When the build is complete, the command window will prompt the user to press any

key to continue. Proceed by pressing any key on your keyboard; as a result, a hex file

for the demo will be created in the following path:

<Z8051 Installation>\Z8051_<version_number>\samples\Z51F3220\Demo\demo.hex

3. Set up the OCD and Development Board. If you have not already configured these

items, please return to the

Board

4. Run the Z8051 OCD software. From the

Zilog Z8051 Software and Documentation <version_number>

OCD <version_number>

shown in Figure 16.

Note:

If you encounter a message that says

OCD and Z51F3220 Development Board

power-up sequence. If the problem persists, Zilog recommends that you review the

OCD Driver Installation

UM024303-0312

Z8051 Tools Product User Guide (PUG0033)

Configure the Z8051 OCD and Z51F3220 Development

section on page 17.

. Once launched, the program will display Connected, as

and

FTDI USB-to-UART Driver Installation

build_sdcc.bat

for additional information about

Start

menu, navigate to

, return to the

Disconnected

section on page 17 to configure the proper