Table of Contents
Advertisement
When the first option is selected the display will be as indicated in fig 3.4.6. The panel is
requesting the output number (1 to 64) which requires to be programmed to operate on operation
of specific loop input devices. The output number is entered and accepted in the usual manner.
Once entered the S, which is the 'clear' status, can be actioned. The S indicates that after being
activated the output will be cleared when the alarms are silenced. Pressing any numeric key will
cause the S to change to R. This indicates that the output will remain active until the panel is
reset. The default status after clearing the memory is to the S mode. However once programmed
to the R status, when the output is again selected it will automatically display the R. Once the
correct status is displayed it is accepted by operating the ENTER/YES key upon which the
display will request the loop number, see fig 3.4.7.
TUE 15 MAR 21:45 PROGRAM PANEL OUTPUTS
The loop number required is that to which the input device, which will activate the output, is
connected. Again this is entered in the usual manner. The display will update and will indicate
the active status of the first device on that loop with respect to the selected output, see fig 3.4.8.
TUE 15 MAR 21:45 PROGRAM PANEL OUTPUTS
The O indicates that the output will be operated. This can be toggled to the active mode by
operating any numeric key. The O will be replaced by an A and, if left in this mode will be
automatically indicated as such when next selected. At this stage the CANCEL/NO key will
return the display to the loop request mode upon which a new loop can be selected for the same
output. However if the ENTER/YES key is operated then the display will update to device two
and the appropriate active status will be displayed.
TUE 15 MAR 21:45 PROGRAM PANEL OUTPUTS
After clearing the memory all devices will be in the inactive (O) status. Further operations of the
ENTER/YES key will advance the device number until the maximum of 127 is reached upon
which the display will revert back to the loop select mode.
If a device greater that the first is displayed the CANCEL/YES key will be decrement the device
number the appropriate active status being updated accordingly. On reaching the first device the
CANCEL/NO key will also refer the display to the loop select mode.
TM0064
OUTPUT 12 R L ? D
Fig 3.4.7
OUTPUT 12 R L 02 D 001 O
Fig 3.4.8
OUTPUTS 12 R L 02 D 002 A
Fig 3.4.9
Page 64 of 91
Issue 2.01
Advertisement
Table of Contents
