Menu Three Options; Print Panel Outputs - Kidde Fire Protection ANTARES Manual

3.4

MENU THREE OPTIONS

When the PROGRAM OUTPUTS option is selected on the menu two the LCD/VFD will
change and display the PROGRAM OUTPUTS ENTERED message and then after two
seconds will display the first option of menu three.
TUE 15 MAR 21:45 PRINT PANEL OUTPUTS
There are eight options available on the panel, option 7 requires the use of the Psion. The
options can be scrolled through using the CANCEL/NO key. The eight options are:
1.

Print panel outputs

2. Print loop devices
3. Print loop outputs
4. Program panel outputs
5. Program loop devices
6. Program loop outputs keypad range
7. Load/save program data - Psion Range
8. Clear program outputs - keypad
The required option is displayed using the CANCEL/NO key after which it is selected by
operating the ENTER/YES key.
3.4.1 Print Panel Outputs
The display options allows the input devices that will activate outputs to be listed on the
LCD/VFD display and, if it is enabled, hard copier to the printer. When selected the initial
display presentation is illustrated in fig 3.4.2.
TUE 15 MAR 21:45 PRINT PANEL OUTPUTS
This indicates the start of the listing and provides a heading for the hard copy when the printer
is enabled. The next line states the output number and its 'CLEAR' status. This will only be
displayed and printed if there are any active inputs assigned to that particular output, see fig
3.4.3.
TUE 15 MAR 21:45 PRINT PANEL OUTPUTS
TM0064
Fig 3.4.1
PANEL O/P ACTIVE LIST
Fig 3.4.2
O/P 01 CLEARED ON 'S'
Page 61 of 91 Issue 2.01