Print Loop Devices - Kidde Fire Protection ANTARES Manual

If there are active inputs, i.e. those with an A status, these are listed after the output number. The
display scrolls automatically through the device on loop one, and then loop 2 etc,. Having
completed panel output one, the system will proceed to panel output two and so on until all sixty
four outputs have been listed.
If enabled the above information will be downloaded to the printer. The printer format is
indicated below:
LOOP 02 DEVICE 120
LOOP 02 DEVICE 100
LOOP 01 DEVICE 060
O/P 10 CLEARED ON 'S'
LOOP 02 DEVICE 080
LOOP 01 DEVICE 060
O/P 01 CLEARED ON 'R'
THU 24 NOV 21:45
PANEL O/P ACTIVE LIST
The listing can be aborted by operating the CANCEL/NO key. A LISTING TERMINATED
message will be generated. As with all other options the occurrence of a fire of fault condition
will automatically terminate the listing.
If allowed to complete the listing a LISTING COMPLETE message is obtained.

3.4.2 Print Loop Devices

The active listing described above can also be obtained for the loop outputs. The listings are
separated into two options. The first listing gives the output numbers with the output device
location, i.e. loop number and address, that has been assigned to it. The display and printer
formats are as illustrated below.
TUE 15 MAR 21:45 PRINT LOOP DEVICES
The active listing described above can also be obtained for the loop outputs. The listings are
separated into two options. The first listing gives the output numbers with the output device
location, i.e. loop number and address, that has been assigned to it. The display and printer
formats are as illustrated below.
TM0064
Fig 3.4.3
LOOP OUTPUTS DEVICE LIST
Fig 3.4.4
Page 62 of 91 Issue 2.01