Device Fault; Pre-Alarm - Kidde Fire Protection ANTARES Manual

FIRE 01 Main Reception Area
ZONE 11 BREAK GLASS DEVICE 066 LOOP 01
The first line of the LCD/VFD display also gives the device location message. If the panel
has not been programmed the display will read LOCATION NOT ASSIGNED.
Scrolling of multiple alarms is achieved using the 'Scroll Alarms' button. For each press of
the button the display will increment the fire count and display the relevant device
information. When the last fire is displayed a further operation of the button will revert the
display back to the first alarm. Also if the display is left on any fire other than the first, then
after the last operation, there is a time-out which will revert the display back to the first alarm.

2.4.4 Device Fault

FAULT 01 Main Reception Area
ZONE 11 BREAK GLASS DEVICE 066 LOOP 01
In the event of a device fault, the panel automatically displays FAULT and the location
information relating to the faulty device(s). Associated with this is a number which indicates the
number of devices in fault. In the event of multiple faults, operation of the scroll alarms button
will step the display through the devices that are in a fault condition. The number adjacent to the
fault indicates the fault number. The display format of the LCD/VFD is shown in Fig 1.4.5. If
any 'system faults' exist these will be included in the scrolling after all the devices have been
displayed.

2.4.5 Pre-Alarm

PREAL 01 Main Reception Area
ZONE 11 BREAK GLASS DEVICE 066 LOOP 01
Should a pre-alarm condition be initiated, the display format of the LCD/VFD is as shown on
fig 1.4.6. As with faults, for multiple signals, the display can be scrolled, the number of the
alarm being indicated in a similar manner. Also the text message programmed to that address
will be displayed.
Pre-alarms inhibit the display of the device and systems faults.
TM0064
Fig 1.4.4
Fig 1.4.5
Fig 1.4.6
Page 36 of 91
TOT>03
Issue 2.01