Kidde Fire Protection ANTARES Manual page 47

LOOP 02 DEVICE 110 DEIS?
The action will be placed in the event log and will be printed out if the printer is enabled. When
going from de-isolated to isolate status the DEVICE ISOLATED LED will be illuminated. The
device can now be de-isolated by operating the ENTER/YES key or the menu reverted to the
device select level by operating the CANCEL/NO key.
If the device is already isolated when selected the display will indicate as shown in fig 3.2.6.
When de-isolated by operating the ENTER/YES key the event will be logged and hard copied
if the printer is enabled. If it was the only device isolated the DEVICE ISOLATED LED will
be extinguished.
Multiple operation of the CANCEL/NO key will return the system back through each stage to
the first option level indication. From any stage the selection can be re-commenced.
Zonal isolate/de-isolate
If no numeric entry is made after entering the Select device mode section 3.2.1 then, upon
operating the ENTER/YES key the zone isolate mode will be entered and the display will be as
shown if fig 3.2.7.
TUE 15 MAR 21:45 ISOLATE A DEVICE
ZONE?
The required zone number is entered and expected upon which the panel will check the
existing isolate status of the selected zone and will then display as shown in figs 3.2.8. and
3.2.9. depending on the status.
TUE 15 MAR 21:45 ISOLATE A DEVICE
ISOLATE ZONE 06
TUE 15 MAR 21:45 ISOLATE A DEVICE
DE ISOLATE ZONE 06
Both Single and Zonal device isolate will prevent operation of the appropriate loop output
devices when they are isolated.
Operation of the ENTER/YES will action the appropriate request. The DEVICE ISOLATE LED
TM0064
Fig 3.2.6
Fig 3.2.7
Fig 3.2.8
Fig 3.2.9
Page 47 of 91 Issue 2.01