Led Test; Printer Status - Kidde Fire Protection ANTARES Manual

The panel will first request the loop number. On entering the loop number the panel will enter
the test mode. If only a zone is required to be tested then, at the loop number request the
ENTER/YES key is operated before entering any data. The display will now request the zone
number which can be entered of the normal manner. When in the test mode the display indicates
the zone or loop selected.
TUE 15 MAR 21:45 SELECT TEST MODE
When in TEST MODE the buzzer will sound in the pulsed mode and cannot be silenced
under any condition. The TEST MODE is cancelled either by the CANCEL/NO key, or the
ACCESS/INHIBIT keyswitch, or the activation of a device not located in the test loop or
zone. When cancelled a TEST MODE TERMINATED message is displayed for two
seconds. it will also be hard copied to the printer.
When a 'test' device is activated the display will alternate between the fire message and the
test mode message also the devices base LED will still be activated to indicate that the panel
has received the call.
The test mode will automatically carry out a 'panel reset' about twenty five seconds after a test
device is activated. A further device can now be tested. The test fire condition will not cause
the internal sounder to go into the continuous mode.
By the addition of the appropriate output card module an output that is active during test mode
can be provided.

3.2.6 LED Test

This option allows the operator to carry out an LED test. All the zone and status LEDs will
illuminate for approx three seconds. The LCD/VFD will confirm the operation by displaying
LED TEST. The installed software version is also displayed.
By the addition of the appropriate output card a signal is available which is active when LED
TEST is operated.

3.2.7 Printer Status

This is only displayed if the printer is configured on the main processor.
When stepping through the menu one options using the CANCEL/NO key the last option
displayed is the printer enable/disable function. The message displayed is dependent on the
current printer status. The two printer status options are displayed in figs 3.2.20 and 3.2.21.
TUE 15 MAR 21:45 PRINTER STATUS
TM0064
** TEST MODE LOOP 01 **
Fig 3.2.19
Page 51 of 91 Issue 2.01