Kidde Fire Protection ANTARES Manual page 57

The send option transmits a complete file of loop data to the panel. Upon selection the Psion will
request whether the temporary file is to be used or one stored in the C datapack. The temporary
file is one created by the Psion when data is transferred to it from the panel or from another
computer. This is explained in more detail in the Load section.
Send Temp File or
select from 'C'
Enter 'Y' for temp
If Y is selected then the temp file, which had been previously loaded, will be transmitted to the
panel. Both the panel and the Psion, see fig 3.3.15, will display the data for each device as it is
down loaded.
When the file is fully loaded the panel will revert to the loop request level and the Psion to the
keypad mode. A new loop can now be selected upon which display and control is again
transferred to the Psion.
If no temporary file exists the Psion will revert back to its previous level.
Device 32
Zone 12
Bedroom 10 1st floor
If, at the file select stage, any other key is pressed the Psion will examine the C datapack and will
display the first file it finds, see fig 3.3.16. The remaining files can be examined by operating the
Psion DEL key. When the required one is displayed it is selected using the Psion EXE key.
EXE to accept
DEL for next file
C:MAIN
When all the files on C have been displayed the display will request a further scroll or
cancellation of the option.
TM0064
Fig 3.3.14
Fig 3.3.15
Fig 3.3.16
Page 57 of 91 Issue 2.01