USC U-Batch Operator's Manual page 40

1
2
3
1. PUMP 1 H-O-A MODULE:
motor. The HAND button will place the pump motor on in the manual mode of
operation. When it is active it will turn yellow. The OFF button will turn the motor off
in the manual mode of operation. When it is active it will turn red. The AUTO button
will place the device in the automatic mode of operation. When it is active it will turn
green. Pressing the REVERSE PUMP button will place the pump in HAND mode but
the pump will be running backwards.
2. LIQUID PURGE MODULE:
compressed air used to clean the supply line. The HAND button will place the solenoid
in the manual mode of operation. When it is active it will turn yellow. The OFF button
will switch the solenoid to the closed position. When it is active it will turn red.
The AUTO button will place the device in the automatic mode of operation.
When it is active it will turn green.
3. POWDER :
Press the Run Time button and use the numeric keypad to enter the
number of seconds for the air to run while delivering powder from the hopper to the top
of the mix hopper. Pressing the START button engages the solenoid to begin air flow
to the supply line of the powder delivery hopper.
4. PUMP MOTOR PERCENT SPEED:
pad will appear to allow the operator to adjust the speed of the liquid mix motor.
It drives the motor to a specified percentage of the maximum pump speed.
Page 40
U-BATCH™ TREATER
H-O-A PUMPS SCREEN
This module controls the function of the liquid pump
This module controls the function of solenoid for the
When this button is pressed, a numeric touch
4