USC U-Batch Operator's Manual page 39

U-BATCH™ TREATER
H-O-A TREATER SCREEN
2. MIXER CONTROL MODULE:
This module controls the function of the mixing
auger motor. The HAND button will place the auger in the manual mode of operation.
The OFF button will turn the associated device in the OFF mode of operation.
The AUTO button will place the device in the automatic mode of operation. The motor
will not operate in this function unless all other needed devices are in the AUTO mode
and the Start Blend button is pressed on the Blend Setup screen.
3. RAISE TREATER CONTROL MODULE:
This module controls the function of the
treater hydraulic lift motor. The HAND button will place the motor in the manual mode
of operation. The OFF button will turn the associated device in the OFF mode
of operation. The AUTO button will enable the Raise Treater button on the
Load / Unload screen. This module will only be present if the hydraulic lift option
is on the treater.
4. LOWER TREATER CONTROL MODULE:
This module controls the function of the
treater hydraulic lift motor. The HAND button will place the motor in the manual mode
of operation. The OFF button will turn the associated device in the OFF mode
of operation. The AUTO button will enable the Lower Treater button on the
Load / Unload screen. This module will only be present if the hydraulic lift option
is on the treater.
5. MIX MOTOR PERCENT SPEED:
When this button is pressed, a numeric touch
pad will appear to allow the operator to adjust the speed of the mix motor. It drives
the motor to a specified percentage of the maximum mix speed. This value may
be changed while the mix motor is running.
Page 39