USC U-Batch Operator's Manual page 11

1. Keep safety labels clean and legible at all times.
2. Replace safety labels that are missing or have become illegible.
3. Replaced parts that displayed a safety label should also display the current label.
4. Replacement safety labels are available. Contact USC at (785) 431-7900 .
How to Install Safety Labels:

Be sure that the installation area is clean and dry.

Be sure temperature is above 50

Decide on the exact position before you remove the backing paper.

Remove the smallest portion of the split backing paper.

Align the sign over the specified area and carefully press the small portion with
the exposed sticky backing in place.

Slowly peel back the remaining paper and carefully smooth the remaining
portion of the sign in place.

Small air pockets can be pierced with a pin and smoothed out using the piece
of sign backing paper.
Think SAFETY! Work SAFELY!
REMEMBER—If safety labels have been damaged, removed, become illegible, or
parts replaced without safety labels, new labels must be applied. New safety labels are
available from USC at (785) 431-7900.
Part # 09-02-0002
U-BATCH™ TREATER
SAFETY LABELS
o o
F (10 C).
Page 11