Section D; Electrical Operation - USC U-Batch Operator's Manual

Section

Electrical Operation

D
This section provides a general overview and description of the operator controls for
the U-Batch™ Treater.
USC recommends the use of a surge protection device with
NOTICE
a minimum rating of 400 Joules for all automated main control
panels.
The E-Stop Reset push button must be pressed after every power
NOTICE
cycle and every time the E-Stop is activated or the system will not
operate.
General Panel Descriptions
The U-Batch™ Treater control panel is a 30 x 24 x10 inch enclosure that contains

all of the electrical control components as well as the HMI (Human/Machine
Interface) touch screen. The operator is able to control the entire system
through the HMI.
Page 24
U-BATCH™ TREATER
HIGH VOLTAGE ~ Always disconnect the power source
before working on or near the control panel or lead wires.
HIGH VOLTAGE ~ Use insulated tools when making
adjustments while the controls are under power.
AUTHORIZED PERSONNEL only shall work on the control
panel. Never allow anyone who has not read and familiarized
themselves with the owner's manual to open or work on the
control panel.