USC U-Batch Operator's Manual page 35

1
2
3
4
1. ACTUAL OUNCES:
actual ounces applied during the calibration procedure.
2. TOTALIZER OUNCES:
amount of ounces the system should have been applied.
3. TOTALIZER:
This display indicates the amount of chemical the program estimates
it applied on the last run.
4. APPLY:
After the actual ounces and totalizer ounces have been entered, the
calculated ratio will be updated. Pressing this button returns the operator to the liquid
editing screen and updates the calibration ratio.
5. SCREEN EXIT:
screen. It's functionality is the same throughout all of the HMI screens.
6. SELECTED LIQUID:
calibration.
7. CALCULATED RATIO:
will be adjusted when the apply button is pressed.
8. CURRENT RATIO:
9. DEFAULT:
Pressing this button returns all values to the default setting of one.
The actual ounces will always be the amount caught by either
a calibration tube or other measuring device. The target ounces are
the amount that should have been caught in the measuring device.
NOTICE
The operator may use the amount they physically measured, or the
totalizer amount. The totalizer amount is the programs estimation
of what the measuring device should have received.
U-BATCH™ TREATER
PUMP SCREEN
Pressing this button brings up a keypad used to enter the
Pressing this button brings up a keypad used to enter the
Pressing this button returns the operator to the recipe editing
This display indicates the name of the chemical for this
This display indicates the amount the current calibration
This display indicates the current calibration.
5
6
7
8
9
Page 35