YASKAWA Sigma-V Series User Manual page 85

Step Display after operation
4
5
6
7
8
9
Alternate
display
6.3 JOG Operation Using a Panel Operator
Keys
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
Operation
Press the DATA/SHIFT Key for approxi-
mately one second. The display shown on
the left appears.
Press the MODE/SET Key to turn the
servomotor power ON.
The servomotor will rotate at the speed
set in Pn304 while the UP Key (for for-
ward rotation) or DOWN Key (for
reverse rotation) is pressed (The factory
-1
setting is 500 min ).
Forward
Reverse
Confirm that the servomotor operation is
correct. At the same time, carefully
inspect the servomotor's condition and
check the following points in particular.
If a problem is found, correct it.
• Is there any unusual vibration?
• Is there any unusual sound?
• Is the temperature rising unusually
high?
Press the MODE/SET Key to turn the
servomotor power OFF.
Note: The servomotor power can be
turned OFF by pressing the DATA/
SHIFT Key for approximately one
second.
Press the DATA/SHIFT Key for approxi-
mately one second. "Fn002" is displayed
again.
Press the MODE/SET Key to return to
the initial display (step 1).
(cont'd)
6-7