Charging Station - Husqvarna Automower 435X AWD Workshop Manual

Note: Make sure to put the cable in the clip and pull
it away from the loop sensor.
5.10.3 To replace the charging plates
1. Remove the rear unit. Refer to
the rear unit on page 24 .
2. Remove the rear body. Refer to
install the rear body on page 27 .
3. Remove the screw for the cover.
4. Remove the cover.
1061 - 001 -
To remove and install
To remove and
5. Tilt the charging plates.
6. Remove the charging plates.
A
7. Install in opposite sequence.

5.11 Charging station

The charging station consists of a baseplate and a
charging tower with the charging station's circuit board
and the contact plates. When the product's battery does
not recharge or cannot contact the charging station this
may be due to worn contact plates in the charging
station. Also check the charging plates on the product.
5.11.1 To remove and install the charging station
and the charging station cap
This section describes how to remove all parts of
charging tower. For service or changing of spare parts
all steps may not be needed.
1. Disconnect the power supply.
2. Push the button and tilt the charging station cap.
B
Repair instructions - 57