Husqvarna Automower 435X AWD Workshop Manual page 43

6. Push the clip with a flat screwdriver.
7. Remove the front circuit board bracket.
8. Install in opposite sequence.
5.8.4 To replace the communication circuit board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
1061 - 001 -
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the front top cover. Refer to
install the front top cover on page 13 .
2. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
3. Remove the front body. Refer to
install the front body on page 14 .
4. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
5. Turn the front upper chassis upside down.
6. Remove the 2 screws.
7. Carefully lift the communication board.
8. Disconnect the cable.
To remove and
To remove
To remove and
To remove
Repair instructions - 43