Husqvarna Automower 435X AWD Workshop Manual page 44

9. Remove the communication circuit board.
10. Install in opposite sequence.
CAUTION: Make sure to connect the
connector correctly to the communication
circuit board.
5.8.5 To replace the front loop circuit board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the front top cover. Refer to
install the front top cover on page 13 .
2. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
3. Remove the front body. Refer to
install the front body on page 14 .
44 - Repair instructions
To remove and
To remove
To remove and
4. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
5. Remove the front circuit board bracket. Refer to
remove and install the front circuit board bracket on
page 42 .
6. Disconnect the CAN cable.
7. Remove the front loop sensor.
8. Install in opposite sequence.
To remove
To
1061 - 001 -