Husqvarna Automower 435X AWD Workshop Manual page 47

7. Remove the 2 screws.
8. Twist the holders counterclockwise around the
steering pins (A).
9. Remove the holders from the steering pins.
1061 - 001 -
A
10. Remove the 3D circuit boards from the holders.
11. Install in opposite sequence.
12. Connect the product to Autocheck.
13. Configure and calibrate the new circuit board.
5.8.9 To replace the front motor control circuit
board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the front top cover. Refer to
install the front top cover on page 13 .
2. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
3. Remove the front body. Refer to
install the front body on page 14 .
4. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
5. Remove the front circuit board bracket. Refer to
remove and install the front circuit board bracket on
page 42 .
To remove and
To remove
To remove and
To remove
To
Repair instructions - 47