Link Arm - Husqvarna Automower 435X AWD Workshop Manual

5.5 Link arm

5.5.1 To replace the handle
1. Remove the rear unit. Refer to
the rear unit on page 24 .
2. Remove the front top cover. Refer to
install the front top cover on page 13 .
3. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
4. Remove the front body. Refer to
install the front body on page 14 .
5. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
6. Turn the product upside down.
7. Remove the 2 screws (Torx 27) that hold the lower
handle.
8. Remove the lower handle.
32 - Repair instructions
To remove and install
To remove and
To remove
To remove and
To remove
9. Remove the 2 screws (Torx 27) for the handle
support.
10. Push the upper handle to the stop position.
11. Remove the upper handle and the handle support.
A
Note: The upper handle must be in stop position to
be removed.
B
1061 - 001 -