Troubleshooting; Messages - Husqvarna Automower 435X AWD Workshop Manual

7.1 Messages

This chapter will guide how to troubleshoot the product. There are references to menus in the product, but Autocheck
can also be used in many cases.
Note: Refer to the Operator's manual for more information about how to rectify errors.
Messages
Number Message
BATTERY
11 Low battery
12 Empty battery
30/66 Battery problem
58 Temporary battery
problem
60 Temporary battery
problem
62 Temporary battery
problem

64 - Troubleshooting

7 Troubleshooting
Cause
The product cannot find the charging
station.
The battery is spent.
Refer to number 11 above
Battery not connected properly, or faul-
ty
Wrong type of battery
The battery is faulty
Wrong type of battery.
Battery temp sensor defective.
Wrong type of battery.
Battery temp sensor gives low or high
temperature reading.
Action
Break in the guide wire. Check the LED
on the charging station. Refer to
troubleshoot the loop signal on page
73 .
Change the position of the guide wire.
Installation - Installation of the
Refer to
guide wire in the Operator's manual.
Check the installation settings about
how to find the charging station.
Perform a battery test. Refer to
eck service tool on page 9 .
Refer to number 11 above
Dismantle the product and check that
the battery is properly connected to its
To replace the bat-
connector. Refer to
tery on page 55 .
Use only original batteries recommen-
ded by the manufacturer.
Replace the battery, refer to
the battery on page 55 .
Use only original batteries recommen-
ded by the manufacturer.
Replace the battery. Refer to
place the battery on page 55 .
Use only original batteries recommen-
ded by the manufacturer.
Make sure that the operating conditions
are within the battery specification. Re-
Autocheck service tool on page
fer to
9 .
To
Autoch-
To replace
To re-
1061 - 001 -