Led Indicator Lamp On The Charging Station; Led Indicator Lamp On The Product - Husqvarna AUTOMOWER 550H Operator's Manual

6.4 LED indicator lamp on the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
any other color than green is visible, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Green solid light Good signals
Green flashing light The signals are good and
vated.
Blue flashing light The boundary loop is not connected to the
charging station.
Break in the boundary loop.
Red flashing light Interruption in the charging station's antenna. Contact your local Husqvarna representative.
Red solid light Fault in the circuit board or incorrect pow-
er supply in the charging station. The fault
should be rectified by an authorized service
technician.

6.5 LED indicator lamp on the product

There is a LED indicator lamp on top of the product, which shows the current status:
Light Cause
Green solid light The product is either mowing the lawn, or
leaving the charging station.
Blue solid light The product is either paused, parked, charg-
ing or is searching for the charging station.
Yellow solid light The STOP button has been pressed.
Red solid light The product has stopped due to an error.
Yellow flashing light The product requests the PIN code.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
42 - Troubleshooting
Action
No action required
ECO mode is acti- No action required. For more information on
ECO mode . Refer to ECO mode on page 24 .
Check that the boundary wire connectors are
fitted properly to the charging station. Refer
To install the boundary wire on page 19 .
to
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Contact your local Husqvarna representative.
Action
No action required.
No action required.
Press the START button on top of the prod-
uct to start it again.
Clear the error by pressing the STOP button,
and then activate the product by pressing the
START button on top of the product.
The PIN code needs to be confirmed in the
Automower
can be activated.
®
Connect app before the product
1457 - 012 - 19.01.2023