Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 420 Operator's Manual

Message
SIM card requires
PIN
SIM card locked
SIM card not found
GeoFence problem

7.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
Speak to your Husqvarna customer service for more information.
Light
Green solid light
Green flashing light
Blue flashing light
Red flashing light
Red solid light
1201 - 007 - 20.02.2023
Cause
The SIM card must be unlocked.
The SIM card must be replaced.
®
Automower Connect requires a SIM card to
be inserted in the mower.
The GeoFence is not work due to poor (or
no) communication with the system.
Cause
Good signals
The signals are good and
bled.
The boundary wire is not connected to the
charging station.
Damage in the boundary wire.
Interference in the antenna of the charging
station.
Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by an authorized service techni-
cian.
Action
Make sure the correct SIM PIN has been
entered into the mower's menu (Network >
SIM card). Contact your local Husqvarna rep-
resentative if this message appears often.
Contact your local Husqvarna representative.
Contact your local Husqvarna representative.
Contact your local Husqvarna representative.
Action
Usual operation of the product.
ECO mode is ena-
Usual operation of the product. Refer to
mode on page 30 .
Make sure that the boundary wire is correctly
installed in the charging station. Refer to
install the boundary wire on page 19 .
Find out where the damage is. Replace the
damaged section with new boundary wire.
Speak to your Husqvarna customer service.
Speak to your Husqvarna customer service.
ECO
To
Troubleshooting - 45