Service; Servicing Tool; Service Schedule - Husqvarna Automower 435X AWD Workshop Manual

6.1 Servicing tool

Item Description
1 Mandrel

6.2 Service schedule

The table below contains a checklist of points and actions to be taken when servicing the product. Complete service
plans can be found in Autocheck.
Every Every Action
3rd
year year
Remove the body and clean the chassis.
X
Clean the ultrasonic sensors carefully.
X
Clean the headlights carefully. (Automower
X
435X AWD)
Check the cable to the product's charging
X
plates. Replace if damaged.
Check all rubber grommets into the chassis that
X
they seal properly. Replace if damaged.
Check the cable and cable terminals to the
X
charging plates in the body.
Check the ventilation filters and clean carefully
with a soft brush.
X
Check the tightening torque of screws on the
X
chassis.
Check the blades and blade screws. Replace if
X
damaged.
X Clean the charging station.
Check and polish the charging plates on the
X product and in the charging station.
X Make a complete
Check that docking and charging work correct-
X
ly.
Do a
X
battery condition.
1061 - 001 -
Auto test in Autocheck.
Battery test in Autocheck and check the

6 Service

Use for
To remove the rear body
Explanation
Refer to
page 14 and To remove and install the rear
body on page 27 .
Refer to
page 45 .
®
Refer to
for the front unit on page 23 and To clean or re-
place ventilation filter for the rear unit on page
31 .
Refer to
Refer to
the Operator's manual.
Polish contact surfaces on both the product and
the charging station with a fine grade emery
cloth.
Refer to
Refer to
Symptoms during charging on page 72 .
and
Refer to
Article number
577 90 66-01
To remove and install the front body on
To replace the ultrasonic sensors on
To clean and replace ventilation filter
Screw fasteners on page 62 .
Maintenance - Replace the blades. in
Auto test on page 10 .
Symptoms during docking on page 71
Auto test on page 10 .
Service - 61