Husqvarna Automower 435X AWD Workshop Manual page 29

5.4.5 To remove and install the rear upper chassis
1. Remove the rear unit. Refer to
the rear unit on page 24 .
2. Remove the rear body. Refer to
install the rear top cover on page 26 .
3. Remove the pivot arm. Refer to
install the pivoting arm on page 28 .
4. Remove the waranty seal at the point of seperation
between the rear upper and lower chassis.
5. Remove the 8 screws that hold the rear upper
chassis.
6. Carefully lift the rear upper chassis.
1061 - 001 -
To remove and install
To remove and
To remove and
7. Disconnect the battery cable (A).
C
A
8. Disconnect the rear main cable (B) and the cable for
3D sensor (C).
9. Remove the top rear upper chassis.
10. Install in opposite sequence.
Note: Make sure that all cables are in their cable
holders and are in their correct routing.
B
Repair instructions - 29