Husqvarna Automower 435X AWD Workshop Manual page 49

6. Push the clip with a flat screwdriver.
7. Remove the rear circuit board bracket.
8. Install in opposite sequence.
5.8.11 To replace the rear motor control circuit
board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
1061 - 001 -
placed in a bag with protection against ESD
(electrostatic discharge).
1. Remove the rear unit. Refer to
the rear unit on page 24 .
2. Remove the rear body. Refer to
install the rear body on page 27 .
3. Remove the rear upper chassis. Refer to
and install the rear upper chassis on page 29 .
4. Remove the battery cable from the cable holder.
5. Remove the rear circuit board bracket. Refer to
remove and install the rear circuit board bracket on
page 48 .
6. Disconnect all cables from the rear motor control
circuit board.
To remove and install
To remove and
To remove
To
Repair instructions - 49