Husqvarna Automower 435X AWD Workshop Manual page 51
Hide thumbs
Also See for Automower 435X AWD:
- Operator's manual (68 pages) ,
- Manual (9 pages) ,
- Quick manual (8 pages)
Table of Contents
Advertisement
9. Remove the holders from the steering pins.
10. Remove the 3D circuit boards from the holders.
11. Install in opposite sequence.
12. Connect the product to Autocheck.
13. Configure and calibrate the new circuit board.
5.8.13 To replace the rear loop circuit board
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
To remove and install
1. Remove the rear unit. Refer to
the rear unit on page 24 .
To remove and
2. Remove the rear body. Refer to
install the rear body on page 27 .
To remove
3. Remove the rear upper chassis. Refer to
and install the rear upper chassis on page 29 .
4. Remove the battery cable from the cable holder.
To
5. Remove the rear circuit board bracket. Refer to
remove and install the rear circuit board bracket on
page 48 .
6. Disconnect the CAN cable.
7. Remove the rear loop sensor.
8. Install in opposite sequence.
Repair instructions - 51
- Quick Links:
- Circuit Boards and Sensors
Hide quick links:
Advertisement
Table of Contents
