Husqvarna Automower 435X AWD Workshop Manual page 42

6. Remove the cable from the cable clip.
7. Turn the front top chassis upside up.
8. Remove the screws that hold the HMI cover.
9. Lift the HMI cover up and disconnect the application
board cable from the application board.
10. Install in opposite sequence.
42 - Repair instructions
5.8.3 To remove and install the front circuit board
bracket
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
The front circuit board bracket holds the front loop
sensor circuit board, the ultrasonic circuit board and the
front motor control circuit board into place.
1. Remove the front top cover. Refer to
install the front upper chassis on page 15 .
2. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
3. Remove the front body.
front body on page 14 .
4. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
5. Remove the screw.
To remove and
To remove
To remove and install the
To remove
1061 - 001 -