Husqvarna Automower 435X AWD Workshop Manual page 48

6. Disconnect all cables from the front motor control
circuit board.
7. Remove the front motor control circuit board.
8. Install in opposite sequence.
9. Connect the product to Autocheck.
10. Configure and calibrate the new circuit board.
48 - Repair instructions
5.8.10 To remove and install the rear circuit board
bracket
CAUTION: Always protect the product from
electrostatic discharge, ESD, before you start to
work on electrical components.
CAUTION: If the circuit board is to be checked
in order to evaluate the guarantee, it should be
placed in a bag with protection against ESD
(electrostatic discharge).
The rear circuit board bracket holds the rear loop sensor
circuit board and the rear motor control circuit board into
place.
1. Remove the rear unit. Refer to
the rear upper chassis on page 29 .
2. Remove the rear body. Refer to
install the rear body on page 27 .
3. Remove the rear upper chassis. Refer to
and install the rear upper chassis on page 29 .
4. Remove the battery cable from the cable holder.
5. Remove the screw.
To remove and install
To remove and
To remove
1061 - 001 -