5. Remove the skid plate.
6. Remove the screw (hex key 4) that hold the bearing.
7. Remove the bearing.
1061 - 001 -
8. Remove the 3 screws that hold the blade disc.
9. Remove the blade disc.
10. Install in opposite sequence.
5.6.2 To remove and install the cutting module
1. Remove the blade disc. Refer to
install the blade disc on page 34 .
2. Remove the front top cover. Refer to
install the front top cover on page 13 .
3. Remove the front bumper tail. Refer to
and install the front bumper tail on page 14 .
4. Remove the front body. Refer to
install the front body on page 14 .
5. Remove the front upper chassis. Refer to
and install the front upper chassis on page 15 .
6. Remove the front circuit board bracket. Refer to
remove and install the front circuit board bracket on
page 42
To remove and
To remove and
To remove
To remove and
To remove
To
Repair instructions - 35