Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 450XH Operator's Manual

Message Cause
SIM card requires
The SIM card must be unlocked.
PIN
SIM card locked
The SIM card must be replaced.
SIM card not found
Automower
be inserted in the mower.
GeoFence problem
The is not work due to poor (or no) communi-
cation with the system.
Zone generator prob-
The battery of the FlexiFence accessory is
lem low. The FlexiFence does not operate when
the battery is empty. The product can cut
in the stay-out zone if you start the product
before you charge the FlexiFence.
The temperature in the FlexiFence accessory
is a higher than the maximum limit and is set
to off.

6.4 Indicator lamp in the charging station

The indicator lamp in the charging station must show a solid or flashing green light for a correct installation. If not,
follow the instructions in the troubleshooting guide below.
Speak to your Husqvarna customer service for more information.
Light Cause
Green solid light Good signals
Green flashing light The signals are good and
bled.
Blue flashing light The boundary wire is not connected to the
charging station.
Damage in the boundary wire.
Red flashing light Interference in the antenna of the charging
station.
Red solid light Error in the circuit board or incorrect power
supply in the charging station. The error must
be corrected by an authorized service techni-
cian.
44 - Troubleshooting
®
Connect requires a SIM card to
ECO mode is ena-
Action
Make sure the correct SIM PIN has been
entered into the mower's menu (Network >
SIM card). Contact your local Husqvarna rep-
resentative if this message appears often.
Contact your local Husqvarna representative.
Contact your local Husqvarna representative.
Contact your local Husqvarna representative.
Park the product and charge the FlexiFence
accessory before you start the product.
Put the product in an area with protection
from the sun. Let the temperature of the
FlexiFence accessory decrease before you
start the product.
Action
Usual operation of the product.
Usual operation of the product. Refer to
mode on page 26 .
Make sure that the boundary wire is correctly
installed in the charging station. Refer to
install the boundary wire on page 19 .
Find out where the damage is. Replace the
damaged section with new boundary wire.
Speak to your Husqvarna customer service.
Speak to your Husqvarna customer service.
1230 - 004 - 04.03.2022
ECO
To