Table of Contents
Advertisement
Section 4 - Configuration
The system contains filtering functions to filter traffic based on the network
protocols and source and destination IP addresses or MAC addresses. It also
allows you to block access to certain websites. Go to Features > IP/MAC/
Website Filtering to configure filtering rules.
Configure the following settings for IP/MAC filtering:
Filter Type
Select IP/MAC Filter.
Selection:
Rule Type
Select either Blacklist or Whitelist to deny or permit the following
Selection:
filtering list.
IP / MAC Filter
Select the rule number for configuration (1-16).
Rule Index:
Active:
Select Yes or No to activate or deactivate this rule.
Interface:
Select the LAN or WAN interface to which the rule should apply.
Direction:
Select Incoming or Outgoing for traffic that is received by the router
from an external network (from WAN to LAN) or traffic that is sent out
of the router (from LAN to WAN) respectively. Select both to apply
both directions to this type of traffic.
Rule Type:
Select either IP or MAC. If MAC is selected, enter a MAC address to
be filtered. If IP is selected, enter the below IP address information.
Source IP
Enter the source IP address (and subnet mask) and port that the
Address/Subnet
rule will apply to. Enter 0.0.0.0 for any IP address and 0 for any port
Mask/Port:
number.
D-Link DSL-226 User Manual
IP/MAC/Website Filtering
67
Hide quick links:
Advertisement
Table of Contents
