Fitting Components In Valve Locations - Festo CPV-VI Series Manual

5. Maintenance and conversion

5.2.2 Fitting components in valve locations

Festo P.BE-CPV-EN en 0005e
Please note
– Please note the instructions in the brief description of
the relevant CPV valve terminal with AS-i connection or
the instructions for fitting equipment on the valve plates.
– Please note the instructions on fitting the valve terminal
with valve plates and vacuum generator plates under
"Vacuum generator plates" in chapter 3.
– If the CPV10 valve terminal is fitted with valve plates
with Ident.code F, please note the instructions on fitting
and application in Appendix B1.
– Please note the limits on fitting the CPV valve terminals
with relay plates (Ident.code R). See compatibility list in
this chapter.
Proceed as follows
S
Make sure that the seals are correctly seated between the
components on the valve terminal. They must lie correctly
in the appropriate seal grooves.
Only CPV10/14 valve terminals
S
Check the position of the seals when fitting valve plates
with pneumatic spring valves or double-solenoid valves. It
is not symmetrical (see diagram).
5-11