Cpv Valve Terminal With Pneumatic Multipin - Festo CPV-VI Series Manual

2. Fitting
2.2

CPV valve terminal with pneumatic multipin

Festo P.BE-CPV-EN en 0005e
Only CPV valve terminals which are fitted with appropriate
end plates may be mounted on the pneumatic multipin.
CPV valve terminals with end plates for individual tubing
need to be converted before they can be fitted onto the pneu-
matic multipin. For this purpose fit the appropriate end plates
(see chapter 5 " Converting the end plates" and Appendix B
"Summary of the end plates").
The pneumatic multipin is available in two forms:
– without assembly step: This pneumatic multipin fits flush
with the end plates. The fastening holes for fitting onto a
wall or on the floor are in the connection side of the pneu-
matic multipin.
– with assembly step: This pneumatic multipin projects
over the end plates. The fastening holes are in the step,
thereby facilitating fitting. Two additional holes running
diagonally through this pneumatic multipin also enable
the CPV valve terminal to be fitted from the rear (see
chapter "Summary of system" fig. 1/2).
CPV valve terminals with surface silencers, which are fitted
onto the pneumatic multipin with assembly step, can only be
fitted onto a wall. Use here the holes running diagonally
through the pneumatic multipin. The mounting holes running
vertically through the pneumatic multipin are covered by the
surface silencer.
2-17