Fitting Components In Valve Locations - Festo CPV -VI Series Manual

5. Maintenance and conversion

5.2.2 Fitting components in valve locations

5−10
Please note
Please note the instructions in the brief description of
the relevant CPV valve terminal with AS−Interface con
nection or the instructions for fitting equipment on the
valve sub−bases.
Please note the instructions on fitting the valve terminal
with valve sub−bases and vacuum generator plates
under Vacuum generator plates" in chapter 3.
If the CPV10 valve terminal is fitted with valve sub−bases
with Ident.code F, please note the instructions on fitting
and application in Appendix B1.
Please note the limits for fitting the CPV valve terminals
with relay plates (Ident. code R). See compatibility list in
this chapter.
Proceed as follows:
Make sure that the seals are correctly seated between the
·
components on the valve terminal. They must lie correctly
in the appropriate seal grooves.
Only CPV10/14 valve terminals
Check the position of the seals when fitting valve sub−
·
bases with pneumatic spring valves or double−solenoid
valves. It is not symmetrical (see diagram).
Festo P.BE−CPV−EN en 0503g