Set Date And Time; Simulation Tools - AuCom MVE Series User Manual

CONTROLLER

6.10 Set Date and Time

To set the date and time:
1. Open the Commissioning Menu.
2. Scroll to the date/time screen.
3. Press the button to enter edit mode.
4. Press the and
5. Use the and
6. To save changes, press the
To cancel changes, press the

6.11 Simulation Tools

Software simulation functions let you test the soft starter's operation and control circuits without connecting the soft
starter to mains voltage.
The simulation tools are accessed via the Commissioning Menu. The simulations are only available when the soft
starter is in Ready state, control voltage is available and the controller is active.
NOTE
Access to the simulation tools is protected by the security access code.
The default access code is 0000.
Run simulation
The run simulation simulates a motor starting, running and stopping to confirm that the soft starter and associated
equipment have been installed correctly.
The run simulation provides a safe method of confirming that the installation is operating as expected. The simulation
is particularly useful to confirm the correct configuration of the main and bypass switching devices, fibre-optic
controls and programmable outputs.
Feedback is provided via the display and the status LEDs. The simulation can be terminated at any time by pressing
the EXIT button. The controller will return to the Commissioning Menu.
NOTE
The soft starter must be disconnected from mains voltage.
The simulation is only available when the soft starter is in Ready state.
22
| MVE User Manual (710-17074-00H)
buttons to select which part of the date or time to edit.
buttons to change the value.
button. The MVE will confirm the changes.
button.