PROGRAMMABLE PARAMETERS
9.
Programmable Parameters
9.1
Programming Menu
The Programming Menu lets you view and change programmable parameters that control how the MVE operates.
You can access the Programming Menu at any time, including while the soft starter is running. Any changes to the
start profile take effect immediately.
To open the Programming Menu, press the MENU button while viewing the monitoring screens.
To navigate through the Programming Menu:
•
to scroll through parameter groups, press the
to open a submenu, press the
•
•
to view the parameters in a group, press the
to return to the previous level, press the
•
•
to close the Programming Menu, press the TOOLS button.
Adjustment Lock
You can lock the Programming Menu to prevent users from altering parameter settings. The adjustment lock can be
turned on and off using parameter 15B.
To lock the programming menu:
1.
Open the Programming Menu.
2.
Open the Extended Menu.
3.
Select 'Advanced'.
4.
Enter the Access Code.
5.
Select parameter 15B
6.
Select and store 'Read Only'.
If a user attempts to change a parameter value when the adjustment lock is active, an error message is displayed:
Access Denied
Adj Lock is On
Altering Parameter Values
To change a parameter value:
scroll to the appropriate parameter in the Programming Menu and press
•
•
to alter the parameter setting, use the
decrease the value by one unit. If the button is held for longer than five seconds, the value will increase
or decrease at a faster rate.
•
to save changes, press STORE. The setting shown on the display will be saved and the controller will
return to the parameter list.
to cancel changes, press EXIT. The controller will ask for confirmation, then return to the parameter list
•
without saving changes.
Load/Save Settings
The Load/Save Settings menu requires an access code and allows users to:
•
Load the MVE's parameters with default values
•
Load parameter settings from an internal file
Save the current parameter settings to an internal file
•
In addition to the factory default values file, the MVE can store two user-defined parameter files. These files contain
default values until a user file is saved.
NOTE
Load defaults will not reset any changes to parameter group 20 'Restricted'.
36
| MVE User Manual (710-17074-00H)
button.
Adjustment Lock
or
button.
button.
button.
and
buttons. Pressing
to enter edit mode.
or
once will increase or
Need help?
Do you have a question about the MVE Series and is the answer not in the manual?