Factory Settings; Electrostatic Discharge Awareness; Legal Information - Deif CGC 200 Installation And Commissioning Instructions

Compact genset controller

Hide thumbs Also See for CGC 200:

Table of Contents

CGC 200 installation and commissioning

instructions 4189340806 UK

DEIF does not recommend using the PC USB as the primary power supply for the CGC 200.

The power drawn on start up exceeds the USB standard and may damage the PC.

1.2.3 Factory settings

The controller is delivered pre-programmed from the factory with a set of factory settings. These are based on

average values and are therefore not necessarily correct for your genset. All controller parameters must be

checked before running the genset.

Protect the controller terminals from static discharge during installation. You must also protect the terminals if

you need to remove the controller.

These precautions are no longer necessary once the controller is correctly installed and connected, as re-

quired by the designer's wiring diagram.

DEIF takes no responsibility for the installation or operation of the genset. Contact the genset company if you

have any doubt about installing or operating the genset.

The controller must not be opened by unauthorised personnel. If opened, the warranty is void.

Disclaimer

DEIF A/S reserves the right to change any of the contents of this document without prior notice.

Trademarks

DEIF, power in control and the DEIF logo are trademarks of DEIF A/S.

Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

All trademarks are the properties of their respective owners.

DEIF A/S

Introduction

Page 5 of 32

Table of Contents