Deif CGC 200 Installation And Commissioning Instructions page 28

Compact genset controller

Hide thumbs Also See for CGC 200:

Table of Contents

CGC 200 installation and commissioning

instructions 4189340806 UK

If a CGC 200 file has been saved on the PC, it can be opened, edited and then written to one or more CGC

200s. To use the batch write function:

1. Click the batch read and write icon (

2. Select Write to device.

3. The Batch job (Writing) dialogue box opens.

Select the information that you would like to write and click Run.

4.3.8 Other Utility Software pages

The other utility software pages are not relevant to commissioning the system. See the Operator's manual

for more information about these pages.

4.4 Commissioning using the front panel

4.4.1 Changing parameters using the front panel

To change parameters by using the front panel:

1. Press

and

2. The access code screen opens. The four-digit access code prevents unauthorised people from changing

the CGC 200 setup via the front buttons. The factory default code is 2000. To enter the access code:

DEIF A/S

) on the toolbar.

simultaneously to go into parameter setting mode.

Commissioning

Page 28 of 32

Table of Contents