CGC 200 installation and commissioning
instructions 4189340806 UK
3. Mounting
3.1 CGC 200 mounting
Protect the controller terminals from static discharge during installation.
3.1.1 Mounting of the unit
The unit is designed for mounting by means of two fixing clamps, which are included at delivery.
3.1.2 Unit dimensions and panel cutout
The unit is designed for mounting in the panel front.
In order to ensure optimum mounting, the panel door must be cut out according to the following measure-
ments:
H × W = 68.00 × 80.00 +0.40 mm and -0.00 mm
H × W = 2.68" × 3.15" + 0.02" and -0.00"
78.50
8
Input 5
7
Input 4
Emergency Stop
6
Input 3
5
Input 2
Config. Output 1
4
Input 1
Config. Output 2
3
MPU Input
Config. Output 3
2
-
1
+
Power Supply 8-35 V
,2 A
Relay Outputs 30 V
,1 A
3.1.3 Tightening torques
Unit panel door mounting:
Plug connections (terminals):
DEIF A/S
Gens L
9
Gens N
10
Fuel Output
11
Start Output
12
13
14
15
USB
D002-1112
0.3 Nm (see diagram in "Unit dimensions and panel cutout")
0.5 Nm
43.00
36.00
0.3 Nm
Mounting
94.75
Page 10 of 32