Setting The Field Bus Address - Festo CP-FB5-E Manual

1. Installation

1.2.1 Setting the field bus address

1
Address selector
switch UNITS
figure
2
Address selector
switch TENS
figure
1-6
Please note
The field bus addresses of the CP system cannot be modi-
fied by the master. The CP system can only be addressed
by the field bus address set on the address selector
switch.
Fig. 1/2: Setting the field bus address on the address selec-
tor switches
Set the field bus address of the CP system with the two round
address selector switches. The switches are numbered from
0..9. The arrow indicates the units or tens figure of the field
bus address which is set.
1
2
Festo P.BE-CP-FB5-E-EN en 0112a