Abb Cs31 - Festo CP-FB5-E Manual

2. Commissioning
2.3

ABB CS31

General information
2-8
A CP system can be fitted with a varying number of inputs/
outputs. The addressing of the CP system is based on the
stipulations of the CS31 system bus.
The following applies to the CP system: every 16 bits require
a CS31 bus address. Even a non-complete group of 16 re-
quires a full CS31 bus address.
The following applies when a CS31 system bus is connected
to an ABB Procontic T200:
– The address designation of the inputs and outputs is dif-
ferent from that of the CS31 central processing unit.
– The appropriate module identifiers must be entered in the
configuration table of the T200.
Please note
If possible, select the range n = 0...58 for the address to be
set in the CP node. n+3 < 61 can then also be addressed.
Festo P.BE-CP-FB5-E-EN en 0112a