Contents and general instructions
Designated use
Festo P.BE-CP-FB5-E-EN en 0112a
The CP field bus node type CP-FB5-E described in this manual
has been designed exclusively for use as a slave on the field
bus systems Festo Fieldbus, ABB CS31 and Moeller SU-
COnet K. CP modules from Festo can be connected to CP field
bus node CP-FB5-E. The CP node may only be used as fol-
lows:
–
in accordance with designated use
–
in its original state
–
without any modifications by the user
–
in faultless technical condition.
If additional commercially-available components such as sen-
sors and actuators are connected, the specifiedlimits for pres-
sures, temperatures, electrical data, torques, etc. must not
be exceeded.
Please observe the standards specified in the relevant
chapters and comply with technical regulations, as well as
with national and local regulations.
Warning
If to be used as an explosion-protected operating device,
make sure that:
S electrical contacts are not disconnected under tension
S the completely fitted product with all plugs, adapters
and protective caps complies at least with protection
class IP 64.
V