Table of Contents
Advertisement
5.9.5.3.
The PTZ interface is shown as in Figure 5.46.
Before setup, please check the following connections are right:
➢
PTZ and DVR (WITHOUT HDD) RS485 connection is should be proper. PTZ A B line should be connects
with DVR (WITHOUT HDD) RS 485 port A B.
➢
PTZ address should be known.
Click Save button after you complete setup, you can go back to the monitor interface to control speed
dome .
Please refer to the following sheet for detailed information.
Parameter
Channel
PTZ type
Protocol
Address
Baud Rate
Data Bit
PTZ
Select speed dome connected channel.
There are three types: RS485/Coaxial/All. Please select RS485 mode if you
are connect RS485 cable to connect to the Speed dome (PTZ). Please select
Coaxial mode if you are connecting to the HDCVI PTZ camera.
Please select protocol from the dropdown list.
Set corresponding dome address. Default value is 1. Please note your setup
here shall comply with your dome address; otherwise you cannot control
the speed dome.
Select the dome baud rate. Default setup is 9600.
Default setup is 8. Please set according to the speed dome dial switch setup.
Figure 5.46
Function
116
Advertisement
Table of Contents
