Table of Contents
Advertisement
•
[Channel] Select the number of channels to be set, the default one channel to the network
camera.
•
[Enabled] To enable or disable Motion Detect on particular channel.
•
[Sensitivity] according to the sensitivity level of the lowest, low, medium, high, very high,
the highest six-speed optional. By default is Middle.
Note: where only in motion detection settings and only analog channels can set its sensitivity of
mixed mode / full analog mode.
•
[Region] Click setup; enter the settings area is divided into 16X12 blocks, red area for
motion detection fortified area. The white area is undefended, Settings area. Hold down
the left mouse button, draw settings area. See Figure 4.14 (By default the entire area
selected for monitoring area).
Note: Mixed mode / full motion detection in analog mode only regional settings, and only analog
channels to set their area.
Figure 4.13
40
Advertisement
Table of Contents
