Previous Screen/Next Screen; Ptz Control - CP Plus Cosmic User Manual

2.6.2 Previous Screen/Next Screen

Click it to go to the previous screen/next screen.

2.6.3 PTZ Control

The PTZ setup is shown as in See Figure 2-25.
Please note the commend name is grey once device does not support this
function. The PTZ operation is only valid in one-window mode.
Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux
function, light and wiper, rotation etc.
Speed is to control PTZ movement speed. The value ranges from 1 to 8. The speed 8 is
faster than speed 1. You can use the remote control to click the small keyboard to set.
You can click and
brightness. The PTZ rotation supports 8 directions. If you are using direction buttons on the
front panel, there are only four directions: up/down/left/right.
In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See
Figure 2-26. Please make sure your protocol supports this function and you need to use
mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the screen to
adjust section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ
automatically. The smaller zone you dragged, the higher the speed.
of the zoom, focus and iris to zoom in/out, definition and
Figure 2-25
Figure 2-26
24