Table of Contents
Advertisement
Note: PTZ Activation, you need [shortcut menu] → [PTZ Control], set the preset point, tour
between points, intervals and other parameters
•
[Post Rec] After the alarm ends, the length of time to continue the local recording can be
set between 10 and 300S.
•
[Show Message] on the local host screen, pop-up dialog box prompts warning information .
•
[Send Email] When an alarm is triggered, sends an alarm message to the specified mailbox,
through SMTP settings.
•
[Buzzer] When an alarm occurs, the device sends a "Beep" sound long ring.
•
[Write Log] Check the box here, system can record motion detect log.
•
[FTP Upload] Expressed alarm occurs if the selected channel or video capture channel, the
video file up to a FTP server.
Note: Upload FTP, need to be set accordingly in the [Network Services].
•
[Buzzer] When an alarm occurs, the device sends a "Beep" sound long ring.
•
[Mobile reported]: when an alarm occurs, the device sends a push notification on mobile
client.
4.1.2.2.
Video Mask
When the device captured video images by outside influence, low light, to set the sensitivity
parameter, start the video occlusion alarm, and the linkage function. See Figure 4.17
*Same with motion detection, the DAC mode / full analog and digital channels of video Mask
function differently.
Figure 4.16
42
Advertisement
Table of Contents
