Table of Contents
Advertisement
To start and stop Auto Pan Procedure is as follow:
a. Click on
b. To stop Auto Pan, click on
•
[Auto Scan] Auto scan consistently pans between a left border and a right border that you set
until turned off. Keep in mind that the left border is the starting position and this feature only
goes left to right and continually scans between them, it will not go from the left point to a
right point that is positioned lower or higher than the initial point you set the left border at.
To set Auto Scan, procedure as follow-
a. Use direction key to rotate PTZ camera to set left limit and then click on
b. Use again direction key to set PTZ camera Right limit and then click on
To start and stop Auto Scan Procedure is as follow:
a. Click on
b. To stop Auto Pan, click on
; PTZ will start rotating in 360°.
Figure 3.22
.
.
; PTZ will start rotating in 360°.
button. See Figure 3.22
button. See Figure 3.23
25
Advertisement
Table of Contents
