List Of Em 2040P Cables - Kongsberg EM 2040P Maintenance Manual

List of EM 2040P cables

A set of cables is required to connect the EM 2040P units to each other, and to the
relevant power source(s).
Cable Signal
C1 Video cable
C3 Keyboard
C4 Mouse
C5 AC power
cable
C7 AC power
cable
C8 Ground cable
C10 Ethernet cable
C14 Serial cable
C18 Serial cable
C19 Serial cable
C20 Serial cable
C21 Special cable
C22 Special cable
C25
Power cable
C26 Ground cable
C27 Control cable
C28 Control cable
417420/A
From/To
From Hydrographic Work Station to display
This is a commercial cable. It is normally provided with the display.
From Hydrographic Work Station to keyboard
This is a commercial cable. It is normally provided with the keyboard.
From Hydrographic Work Station to mouse (or another similar device)
This is a commercial cable. It is normally provided with the mouse.
From display to AC power outlet
From Hydrographic Work Station to AC power outlet
From Hydrographic Work Station to vessel ground
From Hydrographic Work Station to Processing Unit
From Hydrographic Work Station to external device(s)
From Hydrographic Work Station to external device(s)
From Hydrographic Work Station to external device(s)
From DGNSS provider toProcessing Unit. Input for correction services.
See Seapath 130 manual for supported solutions.
RS-232 serial line used for DGNSS input, page 52
RS-422 serial line used for DGNSS input, page 53
From Portable Processing Unit to Seapath antenna.
Seapath antenna interface cable - with plug, page 63
Antenna interface cable, page 65
From Portable Processing Unit to Seapath MRU.
Seapath MRU interface cable, page 66
From Processing Unit to AC power outlet
From Processing Unit to DC power outlet
Two versions, one for Portable Processing Unit and one for regular
Processing Unit.
From Processing Unit to vessel ground
From Processing Unit to remote control device
Remote on/off switch
If remote control is not used, a termination plug has to be inserted in the
Remote control plug on the Processing Unit. This plug is a 9 pin D-SUB
supplied with the Processing Unit.
The remote control function is not available for the Portable Processing
Unit.
Remote control, page 55
Remote Control using K-Rem, page 56
Dummy plug for not using remote control, page 57
From Processing Unit to synchronization device
External synchronization
External synchronisation, page 58
Cable layout and interconnections
DC Power cable, page 67
47