Configuring with Web Based Management
6.5 "System" menu
Description
The page contains the following boxes:
● EtherNet/IP Device Diagnostics
Shows whether EtherNet/IP is enabled ("On") or disabled ("Off").
● EtherNet/IP Device Diagnostics for next boot
Set whether EtherNet/IP will be enabled ("On") or disabled ("Off") after the next device
restart.
Note
EtherNet/IP and PROFINET
When EtherNet/IP is turned on, PROFINET is turned off. The switchover from EtherNet/IP
and PROFINET has no effect on DCP.
Note
PROFINET AR Status
If a PROFINET connection is established; in other words the PROFINET AR status is
"Online", you cannot enable EtherNet/IP.
6.5.18
PLUG
6.5.18.1
Configuration
NOTICE
Do not remove or insert the PLUG during operation.
A PLUG may only be removed or inserted when the device is turned off.
The device checks whether a PLUG is inserted at one second intervals. If it is detected that the
PLUG was removed, there is a restart.
If a valid PLUG was inserted in the device, the device changes to a defined error state
following the restart. With SCALANCE W, the available wireless interfaces are deactivated in
this case.
If the device was configured at one time with a PLUG, the device can no longer be used
without this PLUG. To be able to use the device again, reset the device to the factory settings.
210
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03